SAP RFC NO DUMP documentation, setup help and example usage

SECRET
ARTICLE

No ABAP Short Dump if an RFC Logon Fails
Further information about the reason for the logon problem is also missing.

Cause and Prerequisites
ABAP short dumps are only output when an RFC logon fails if profile parameter "rfc/signon_error_log" is contained in the profile file of the corresponding application server :

rfc/signon_error_log = 1

Each time there is a logon error, the short dump "CALL_FUNCTION_SIGNON_REJECTED" is output. The contents of this dump can be analyzed with the short dump analysis transaction (ST22
).

rfc/signon_error_log = 2

In addition to the ABAP short dump "CALL_FUNCTION_SIGNON_REJECTED
", further information about the cause of the problem is logged in the developer trace files (i.e. in dev_w* files).
Each RFC logon attempt is logged in the developer trace files, whether or not the logon was successful. Make sure that this profile value is only used to analyze the RFC logons and then reset. Otherwise the trace files would become very large.

Solution
Add profile parameter rfc/signon_error_log for the corresponding application server instances with the corresponding value assignment (1 or 2, see above) to the profile file. Start the server again with this profile.
To reset the profile parameter, either remove the profile parameter from the profile file or set the profile value to zero (i.e. rfc/signon_error_log = 0). Then start the server again with this profile.

Documentation extract taken from SAP system, � Copyright SAP AG. All rights reserved